Nexo LS1200 Subwoofer to rent

Hire a Nexo LS1200 Subwoofer Speaker to extend the bass frequency range of the Nexo PS15 loudspeaker down to 29 Hz and to give a higher power output (135 dB Peak). The Nexo PS15 and Nexo LS1200 speakers are connected as active, which means that a separate amplifier channel must be used for each speaker.

One Nexo LS1200 is typically used with 2 Nexo PS15 loudspeakers, however, you can use more Nexo LS1200 speakers for an enhanced bass effect.

When you hire a Nexo LS1200 speaker, it must be used with either a Nexo NXAmp or any third party amplifier, in which case you must use either a Nexo PS15TD controller or a Nexo NX241 digitial controller or Nexo NX242 digitial controller, otherwise the sound quality will be poor and the speaker could very likely get damaged.

Due to how the Nexo speakers are connected, when hiring or renting a Nexo speaker, please be aware that on a standard 4 pole NL4 Speakon connector, the 1+ & 1- pins are used to power the bass speaker (Nexo LS1200 in this case) and pins 2+ & 2- are used to power the full range speakers (the Nexo PS15 in this case).  This enables the speakers on each side to be connected using just one NL4 Speakon cable, enabling you to daisy chain the Nexo LS1200 and PS15 (this gives the appearance that they are connected passively, however they are not).

The Nexo LS1200 speaker hire is now in stock and available to hire from HireHop suppliers, call or email them for the latest hire prices.

Specifications:

• Recommended amplifier power 800 watts to 1200 watts RMS into 4 Ohms
• Impedance of 4 Ohms
• Frequency range 29Hz to 130Hz
• Sensitivity 102dB at 1w at 1m
• Nominal Peak SPL @ 1m = 133 to 135 dB Peak (800w to 1200w RMS Amp)
• Height 515mm x Width 791mm x Depth 597mm (20.25" x 31.13" x 23.5" )
• Weight 45kg (99 lbs)
• Use only with correct Nexo amplifiers or dedicated Nexo controllers